On July 28, according to the “Business Daily†report, experts from auto parts makers such as ZF, Temik, and Delphi are developing new chassis that provide comfort while providing safety, because the chassis can be Carry out "thinking" while the car is moving, and automatically and reasonably adapt to the road conditions.
Car developers must face the question of how to adjust the chassis when developing each new model, that is, should adopt a tough sport-style shock absorber, or rather to make the shock softer and more comfortable, but at the same time have to accept safety Lack of motivation.
Leading the field in new chassis is ZF's third-generation electronic continuous shock control system (CDC). What plays a major role in the CDC is a stepless shift shock absorber that can be quickly changed from hard to soft. It receives commands from a controller every two milliseconds. With the help of the sensor, the controller not only monitors the vehicle speed, acceleration and load conditions, but also monitors the accelerator pedal movement and road conditions. An electronic device derives the damping requirements for each tire.
Soft shock absorption should be used under average load and normal driving conditions. In the case of poor driving conditions (such as full load, poor road conditions, cornering, rapid change of line, or sudden braking), the system immediately reacts to automatically adjust the damping system. As the vibration of the tire is reduced, the contact with the ground is not interrupted, thereby enhancing the ability to grip. Therefore, the car can maintain the driving route, react stably in the evasive turn, and reduce the roll.
The glue with good performance also has a large change in melt viscosity with temperature. Specifically: when the use temperature rises above 150 degrees, the melt viscosity of the glue can be quickly reduced, so that the coating can maintain proper permeability; and when the temperature of the glue is lowered, the viscosity of the glue can quickly increase. , and quickly solidifies, thus ensuring the effect of rapid limb binding. Hot melt adhesives can maintain good permeability only if they have a suitable melt viscosity, which is very important for glue binding. But too low melt viscosity will cause insufficient amount of glue on the back of the book. The melting degree of hot melt adhesive is more suitable in the range of 4000-5000 centipoise. Good adhesion and penetration performance, that is, when the equipment is running at high speed, the glue must be able to quickly infiltrate the spine of the book, and have excellent cohesion, which can ensure "no wire drawing", and will not crack or fall apart after cooling. In order to achieve this goal, changing the composition of the glue is one aspect. The key is to improve the cohesion and toughness of the base resin, and to introduce strong adhesive force, hard quality, low melt viscosity into the composition, and when the temperature changes up and down, Resins that dissolve or set rapidly. Adhesives with good performance should also have good tensile strength. The phenomenon of loose pages, falling pages, and breaking during the use of adhesive books is directly related to the tensile strength of hot melt adhesives. The tensile strength is usually 20-30kg/cm2. Hot melt adhesives must have good elongation. The elongation at break is high, and the toughness of the hot melt adhesive is good; only with good toughness can the book not be easily broken. The elongation requirement is greater than 300%
Adhesive Binding,Hot Glue For Book Binding,Glue For Paper Binding,Book Binding Glue Spine
GUANGZHOU INTERNET WOOD GLUE MANUFACTURER CO. LTD. , https://www.hotmeltadhesiveiwg.com