1. The correct operation must be carried out strictly according to the operating instructions of the garbage truck's vehicle manual and the chassis' operating manual.
2. During the loading and unloading work of the compression garbage truck , the operator should always pay attention to the standing position of the surrounding personnel so as to avoid accidental injury when the vehicle is carrying out work.
3. When the vehicle is inspecting and maintaining the loading and unloading mechanism, it is necessary to pay attention to safety. It is forbidden to carry out maintenance work under the condition of lifting and without a reliable support.
4. Compression type garbage trucks are used for loading daily-use garbage and cannot be loaded with construction waste. Otherwise, it will cause damage to vehicle parts.
5. During the loading and unloading work, the cover of the automobile is to be put on the neutral gear, and is running at a low speed, then the clutch pedal is depressed, the start switch of the power take-off is closed, and the clutch pedal is slowly released. At this time, The vehicle understands the car through the power take-off device and the drive shaft to drive the oil pump.
6. Compression type garbage truck loading work: press the button 1 of the closing cylinder, straighten the bracket, and close the button after finishing; put the trash can above the hook of the loading season; press the button of the cylinder 2. The brackets close the door and close the button after the operation is completed. Arangang compresses the cylinder button 4, and the pressure plate begins to compress. When the pressure plate is in the upward direction, the trash can hangs up and flips, dumping the garbage into the hopper and completing the operation. Then press the close button; after pressing the pressure cylinder button 5, the pressure plate will start to rotate and compress, and after the completion, you can press the close button. Turn on the pressure cylinder button 6 again, pay the pressure plate to return, and press the close button when finished; after the trash can landed on the ground, remove the empty barrel and prepare to hang on the trash can; after the loading work is completed, the car Before use, step on the clutch pressure plate and disconnect the Pneumatic switch of the power take-off to stop the oil pump from operating.
7. Compression type garbage truck unloading work: The front handle of the multi-channel valve lifting cylinder is moved forward, the hopper will rise, and then the handle prevents the middle; the handle of the multi-way valve lifting cylinder is again operated. Before pushing, push the plate to discharge. After the unloading is completed, the handle should be pulled back. The push plate and the cylinder are returned, and then the handle is prevented from being in the neutral position; the handle of the vehicle lift cylinder is placed in the rear position, the hopper is lowered and returned, and then the handle is placed in the neutral position. (Text / Sun Ni)
Self Activated Balancing Valve
Dynamic equilibrium means
to control pressure change by some devices for system balance in variable flow system when
process loading changed from 0% to 100% .
The advantage of variable flow systems in dynamic equilibrium case is to save energy,
significantly enhance comfort, improve system efficiency and control
accuracy.
The Self-Acting DP Control balancing valve is used
for dynamic hydraulic balance of
heating and air conditioning systems. It can reduce
the complexity and time-consuming calibration process.
Activated Valve,Pressure Activated Valve,Self Activated Balancing Valve,Self-Actuated Differential Pressure Control Valve
A1BEST International Corporation , https://www.aone-best.com