Formaldehyde detector application range and use method

Formaldehyde detector can be used for real-time computer network monitoring in public places, can be super-line alarm or take control measures; can also be used for real-time monitoring of the plant's related workshops, and can help engineering and technical personnel to analyze and predict the volatile content of products It can also be used as a stand-alone device for the detection of harmful volatiles in the air in the home.

Formaldehyde detector use method:

1, sampling boot: press the switch (ON-OFF), display ----, flash three seconds to check the sensor, when the display shows 0.00 when the instrument is ready for sampling. Sampling: In the atmosphere to be sampled, hold the analyzer, press the sample, display (Run), and hear the internal sampling pump ring for about 2 seconds. Readings: During the instrument's analysis of the sample, you will see a 0.00 flash, visible after about 10 seconds. This is the formaldehyde concentration in ppm. Shutdown: Press the switch (ON-OFF) to turn off the phone. If you forget to turn off the phone, it will turn off automatically after 5 minutes.

2. Sensor reset phase Sensor reset: After a test, it should be turned off for a few minutes to reset the sensor. Generally speaking, the higher the formaldehyde concentration, the longer the reset time will be. If the sensor is not reset before the start of the measurement, it will be visible ---- the flash, and the sampling pump will not work, when you turn on to see the 0.00 flash 3 The second sensor has been reset and the next measurement can only be performed.