The biggest difference in the pressure of the sprinkler is that the filter is clogged. Reasons for filter plugging:
First, the water source problem. Many customers divert water, which is often from ponds, rivers, etc. There are too many impurities in the water. When pumping, the filter screen is easily blocked by debris, such as sand, plastic bags, green vines, algae, or some sundries. . When the water source mixed with debris enters the pipeline, water pump and water tank through the water inlet, it may cause blockage. Even after entering the tank smoothly, during the drainage process, the water outlet pipe may be caused, the water pump is blocked, and the water is discharged. At the end, straight and back sprinkling is not possible to discharge smoothly. After these things are pumped into the tank, the sprinkler will spray the water out. Also, with the direction of the water flow, these impurities will gradually accumulate in the filter screen. If it is long, the filter will be blocked and the water flow will be difficult to pass, resulting in a decrease in water flow;
Second, the problem of water rust. When the sprinkler is relatively old, there will be some rust inside the tank. The longer the rust is generated, the more the filter will be blocked.
Third, the filter is aging or damaged. When the filter is clogged, it will be washed by a certain pressure of water, which may be broken or damaged. In addition, if the filter is used for a long time, it may also be aging, or the filter may be cleaned frequently, causing damage to the filter. The debris enters the inside of the pipeline, causing blockage and causing a decrease in water flow;
Fourth, there are debris in the tank. Because there is a personal orifice above the tank of the sprinkler, if it is not closed, or if there is any debris entering the tank, it will cause the pressure in the tank to be blocked, and the pressure will be too small, and the amount of water will become smaller;
5. The pressure on the sprinkler pump is insufficient. As a result, the sprinkler pump can't pump water, and the insufficient pressure of the sprinkler pump is usually caused by two reasons:
1, the power is too low, the speed is too low, try to increase the throttle;
2. The impeller flow path or the suction line is blocked, or the impeller wear is broken. If it is blocked, the pump should be cleaned. If the impeller is damaged, the impeller needs to be replaced.
If you have any questions or questions about the special car, you can also inquire!
Consult the car hotline: 158-9759-8261 (WeChat with the same number)
Business QQ: 348672181
Knitting Machine,High-Speed Circular Knitting Machine,Custom Knitting Machine,Universal Circular Knitting Machine,Velvet Loom,circular loom
Tianchi Changzhou Textile Machinery Co., Ltd , https://www.tcloom.com