The occurrence of electrical equipment failure of the machine tool not only affects the normal operation of the machine tool, but also reduces the work efficiency of the enterprise. In severe cases, it may adversely affect personal safety and equipment safety, causing huge economic losses to the enterprise. According to the cause of the malfunction of the machine tool, the fault can be divided into human fault and natural fault. The natural fault is mainly caused by the insulation aging of the electrical components, the natural wear of the machine tool, the influence of ambient temperature and humidity, etc.: Man-made faults mainly refer to machine faults caused by unreasonable installation, improper operation or other man-made damage during the working process of the machine tool. After the failure of the machine tool electrical equipment, the maintenance personnel should promptly check and eliminate the fault, and take the practical life and utilization rate of the targeted electrical equipment to achieve higher economic benefits.
Fault classification and maintenance measures
1. According to the location of the fault, the period can be divided into software faults and hardware faults.
2. According to the inevitability of the mechanical and electrical equipment failure of the machine tool, the mechanical and electrical equipment failure can be divided into random faults and system faults.
3. According to the destructiveness of the machine tool electrical failure, the machine tool electrical equipment fault can be divided into destructive fault and non-destructive fault.
4. According to the sports quality of the equipment, with the continuous extension of the service life of the machine tool, the machine tool equipment may produce unqualified products under normal operation conditions, which is caused by the decrease of the motion quality of the machine tool and the decrease of the motion characteristics. .
Maintenance and maintenance of electrical systems
1. Strictly abide by the mechanical and electrical equipment maintenance management system
2. Maintain the input and output devices
3. Regularly check if the electrical system is overheated.
4, regular dust removal
5. Maintain the accuracy of machine tool electrical equipment
(Finish)We have supplied our Lighting poles to Australia, Columbia, England, Kuwait, Iraq, Philippines, Pakistan and etc.
Our Lighting poles are made from quality sheet through bending, forming, automatic welding and hot galvanization. We can reach one-run machining length of 14m and can bend sheet of thickness up to 45mm. We adopt advanced welding procedures, automatically weld main joints and reach rank-II welding quality.
Lighting Pole, Transmission Line Pole, Solar Lighting Pole, Single Arm Lighting Pole
Jiangsu Xinjinlei Steel Industry Co., Ltd. , https://www.jinleisteelpole.com