In terms of operational efficiency and energy saving, the use of automatic control valves is an indispensable part. The manual valves and pneumatic valves commonly used in the traditional industries are inferior to the electric valves in terms of installation cost and efficiency. Industry sources said that in industrial processes, valves are mostly used to control the flow and flow of various fluids, such as water, oil, chemical liquids, and the like, based on parameters such as temperature, pressure and flow. The factory commonly used control valves are pressure reducing valve, pneumatic temperature valve, solenoid valve temperature system, proportional control valve temperature system, temperature control valve and several other types. In the selection of various types of automatic valves, should consider the type of heat engine, the required accuracy, control valve quality, pressure drop, flow and its structure, failure rate, factory credit and after-sales service and other factors in order to achieve economic and practical purposes. As far as the product itself is concerned, it is a more cost-effective option for the industry to have the advantages of easy assembly, low failure rate and meeting the automation needs of the industry. Because the use of conventional pneumatic valve, inevitably have to pipe, solenoid valves and compressors to match, and the motor-driven valve is easy to install and save, and the installation of electric valve with the factory's existing automatic control circuit can save the other the costing payment. In addition, motor-driven opening and closing more smooth, no short-term impact of excessive shortcomings, the failure rate can be significantly reduced. Many people think that electric valve expensive, high cost, is not the case, if the overall calculation, the traditional valve to add many fittings and piping installation, the price is not dominant, but to assume more maintenance costs.
There are two ways to make the logo on the traction pad, one is PVC logo, the other one is EVA color connect logo.
PVC logo is a very simple idea, just make a PVC logo based on the design and insert it into the traction pad. One advantage of PVC logo is that it can be more detailed and complicated than the EVA color connect logo. And it can be repeatly used on other pads without any more setup tooling charge.
The EVA color connect logo is made along with the pad itself. Unlike the PVC logo, it is also EVA material same as pad, and also shows with the texture. The design of this logo can not be too detailed and small, it needs to be larger and simpler so that we can use the different color EVA material to connect them.
EVA Traction Pad is the tail pad to be sticked on the surfboard. It comes with center arch and kick tail, which allow surfers to control the direction and stability when surfing in the sea.
The design of surfboard traction pad can be in one piece, two pieces, or three pieces basically. The standard the classical texture for traction pad would be diamond like texture, as it can provide the stronger grip among all of them.
The EVA color connect logo is made along with the pad itself. Unlike the PVC logo, it is also EVA material same as pad, and also shows with the texture. The design of this logo can not be too detailed and small, it needs to be larger and simpler so that we can use the different color EVA material to connect them.
Eva Traction Pad,Non-Skip Traction Pad,Traction Pad,Surfboard Tail Pads,Grip Tail Pad,Eva Tail Pad
Huizhou City Melors Plastic Products Co., Limited , https://www.melorsmarine.com